|
| |
Sport Kote®
Water-Based Urethane Wood
Finish (222SF)
Features
 |
Single-component formula means no pot life and no mess. Finish is useable the
next day if more coats are desired. |
|
Contains reactive polymers that offer durability and appearance equal or
greater than oil-modified products. |
|
Excellent black mark, scuff and soil resistance. |
| One
hour dry time between coats under normal conditions. |
| Only 24
hour gym down time. |
|
Uniquely restorable with high speed buffer. |
|
Suitable for oak, maple and parquet floors. |
|
MFMA approved - meets
all standards set for group five products, water-based finish.
 |
Properties*
|
Type - Urethane/Acrylic Blend |
|
Form - Opaque Liquid |
|
Odor - Bland |
|
Color - Light Yellow |
|
Weight per Gallon - 8.60 Lbs. |
|
pH - 7.5-8.5 |
|
Floor Solids - 29% |
|
Coverage - Up To 1000 Sq. Ft. Per Gallon (25 m2 Per Liter)
|
|
Slip-Resistance -
UL Classified |
| VOC
Content - 250 gm/L |
*
Properties are typical and subject to usual manufacturing tolerances.
General Directions**
-
Prepare Floor: Note: This finish is not designed for
application to bare wood floors. Use only on previously sealed surfaces.
Scrub and recoat: Dust mop floor and remove all chewing gum and labels. Clean
floor with a 8 ounce per gallon dilution of
Citrus Scrub 'N Shine
(#525). Screen with a 120 grit screen or brown or black pad to
sufficiently roughen floor. Rinse the floor with
Nu-Tral Cleaner (#507)
until all residue has been removed.
Note: Test previously coated floor in an inconspicuous area
before recoating to determine compatibility with existing finish. Apply 2 or 3
coats of finish. See finish application instructions below.
-
Apply Finish: Stir gently before using. Apply at a rate of
800-1000 square feet per gallon. Use a clean, synthetic applicator. Apply
thin, even coats with the grain of the wood. Allow a dry time of at least 1
hour between coats. Humid conditions will necessitate longer dry time. After
the first coat has dried, apply a second coat. It may be necessary to screen
the first coat if grain raising has occurred or it has dried longer than 4
hours. If so, screen the floor with a previously used 120 grit screen or brown
or black pad. Always vacuum and tack thoroughly after screening.
Note: Do not pour unused finish back into original container.
For best results, use product within 1 year of purchase date.
-
Maintain Daily: Dust mop at least daily, or more as required,
to keep floor dust and dirt free. Damp mop spills, salt residue, etc. with
Nu-Tral Cleaner and a thoroughly wrung mop.
-
Maintain Weekly: If soil conditions are heavy, auto-scrub
weekly with red pads and a 2 ounce per gallon dilution of Nu-Tral Cleaner.
Refer to the Wood Floor Care Wall Chart or Manual for further details.
-
Restoration: Dust mop floor. Auto-scrub with red pads with an
8 ounce per gallon dilution of Citrus Scrub 'N Shine. Then dry burnish with
recommended pad.
** See
label directions and MSDS for complete usage and safety instructions.
Application Hints
- Sport
Kote should be gently mixed before application.
- During
application, make sure air handlers are OFF and doors are closed to eliminate
flash drying. After the application is complete and the finish has skinned
over, ventilation can be turned back on.
- Sport
Kote can be applied over most existing finishes including oil-modified
products. If uncertain, test in a small, inconspicuous area for compatibility
first.
- Under
high humidity, dry times for Sport Kote will vary greatly. Do not apply a
second coat if the first coat is still tacky.
- Two
coats is usually sufficient on recoats. If a third coat is desired, make sure
the previous coats are thoroughly dry before applying product.
Burnishing Pad Recommendations *
| |
Propane
|
Battery
|
Electric (1000+ rpm)
|
|
3M
|
Natural Blend Tan
|
Natural Blend Tan
|
Natural Blend Tan
|
|
Americo
|
Porko
|
Porko
|
Porko
|
|
ETC
|
Gorilla
|
Gorilla
|
Gorilla
|
|
Glit
|
Buckeroo
|
Buckeroo
|
Buckeroo
|
|
Microtron
|
Natural Fiber Buff
|
Natural Fiber Buff
|
Natural Fiber Buff
|
|
Norton
|
Grizzly Bear
|
Grizzly Bear
|
Grizzly Bear
|
*
These are generalized classifications based on market research. Terms and
definitions may be different from manufacturer to manufacturer; however, the
above information will help to determine pad compatibility with various floor
machines and Essential finishes on the market.
NOTE: These are polishing pad recommendations. They are not
suitable for deep cleaning a wood floor prior to recoating. See product label
for complete details.
Packaging Specifications
|
Package
|
Sizes
Available
|
UPC Codes
|
Pack
Size
(inches)
|
Cube
(ft.)
|
Pack
Wt.
(Lbs.)
|
Full
Pallet
|
|
|
5 Gallon
Pail
|
783366222056
|
12 x 14
|
1.17
|
46.08
|
36
|
|
|
2 x 2½ Plastic
Container
|
783366222032
|
14 x
9.5 x 15.25
|
1.17
|
45.86
|
36
|
|
|
4 x One Gallon
|
783366222049
|
13 x
13.5 x 12.5
|
1.27
|
36.44
|
36
|
|
